THE URETHANE VARNISH
(L-2, L-3, L-4)

urethane varnish for wood, mat, semi-mat, glossy


APPLICATIONS:
The urethane varnish mat (L-2), semi-mat (L-3), glossy (L-4) is intended for interior protective-decorative paintings on wood and wood-based surfaces (furniture, wainscot etc.).

GENERAL DESCRIPTION:
The lacquer gives an aesthetic and decorative look to the painted surfaces. It is characterised by an excellent adhesion to the surface, resistance to household chemicals and durability. It can also be used as additional protection of painted coats in order to give them mat, semi-mat or glossy look.

The lacquer (L-2), (L-3), (L-4) is certified for use by the National Institute of Hygiene in Warsaw and is recommended for use by the Association of Polish Cabinet-Makers.

PROPERTIES:
Flash time (apparent viscosity): 60-100 s
Specific gravity, max: 0.98 g/cm3
Drying time, max:       3 grade 8 h
                                   6 grade 21 h - 24 h


8 h

to 10 m2/l

12 months

1-2

for phthalate products

DIRECTIONS FOR USE: Stir the lacquer well before use (especially when mat and semi-mat painting). The lacquer is applied by brushing, rolling or air spraying onto clean, polished and dry substrates. For priming, use for example LEAD-FREE NATURAL LINSEED OIL VARNISH (LP-6) diluted with a thinner for general-purpose oil and phthalate-based products (R-2) at a 1:1 solution. After letting the surface dry, polish it with abrasive paper, than apply the lacquer. The next layer of lacquer can be applied after 24 hours.
CAUTION!
Ensure that there are no badly primed raw wood areas otherwise stains may occur when applying the lacquer.




HEALTH AND FIRE HAZARD INFORMATION
The lacquer should be stored in tight containers. When using it in closed areas, ensure that the ventilation system functions properly. Avoid exposure to naked flames. Provisions for adequate ventilation must be made after painting to remove odour

CONTAINER TYPE AND MATERIAL: Metal tins with capacity of 0.8 l;


Application method: